CHR 237 Reindeer Dot Antlers Gingham Nose
ALL PRINTS WILL BE READY WITHIN 48HRS
Please add any special directions in the Notes.
ALL DECALS WILL COME WITH A SMALL WHITE OFFSET
*HTV READY TO PRESS DESIGNS
All HTV Designs come in 5 Sizes.
Sizes may vary based on design.
Please make sure you choose the appropriate size for your project.
HTV Designs can be used on any color shirt and fabric. Due to the variation in monitors and browsers, the colors on the image may appear different on different monitors.
*How to apply HTV to shirt:
Transfer sheet is already applied to design.
Remove Backing from design.
Press at 305 degrees for 5 Seconds.
Remove transfer Sheet and Press for 10 Seconds You're Done!!
*SUBLIMATION READY TO PRESS DESIGNS
If you want a sublimation for a tumbler please make sure you choose the Mug/Koozie/Tumbler 3.5 inch. We will print the design in the center of the page for you to be able to wrap around the tumbler.
For shirts sublimation transfers ONLY work on a 50% or more POLYESTER garment. The shirt may be a blend containing cotton, but the Polyester must be 50% or higher. The higher the Polyester count the bright the image will appear. The transfer must be used on a light-colored fabric such as white/ light gray; pastel colors will work as well. Transfers DO NOT print white, SO the color of your shirt will show up as the white areas on the transfer. No white ink is printed onto the transfer.
LIGHT COLORED FABRICS ONLY.
The color of the transfer you receive may appear slightly dull. The colors of the print will look more vibrant once they are pressed on the shirt. You will need a heat press to use this transfer. Due to the variation in monitors and browsers, the colors on the image may appear different on different monitors.
*How to apply Sublimation to Shirt:
Preheat press to 400 degrees Fahrenheit. Place a piece of butcher paper inside of the shirt. Press garment for 3-5 seconds to release moisture and remove wrinkles. Place your sublimation transfer face down on your garment. You can use heat resistant tape to hold the print in place. Place a piece of butcher paper on top of the design (Teflon sheets are not recommended). Press for 60 seconds at medium to firm pressure.
***Please remember that all heat presses are different and may require a time/temperature adjustment. Peel hot
DO NOT use the same print more than once.